The Mark IV Industrial TrimMaster®, featuring new POWERslot™ technology, provides single user setup and operation
in the shop and on the job site. Non-marring vinyl strips protect clad finishes leaving clean crisp bend lines and hems.
Our unique cam-locking system clamps to the thickness of the material and not to a factory preset. Should you ever need to
fine-tune your brake, each casting comes with independently adjustable UHMW plastic wedges. While some brake manufacturers
have taken away your ability to make these adjustments, its nice to know TrimMaster® gives you the choice, even if you
never have to use it.
| Specifications |
|
Capacities |
| |
|
IT663
6'6"/2.0m
7
119/54.0
Alum. Coil
.040"
.063"
IT863
8'6"/2.6m
9
148/67.1
IT1063
10'6"/3.2m
11
176/79.8
Galv Steel Grade D
24 ga.
20 ga.
IT1263
12'6"/3.8m
13
206/93.4
IT1463
14'6"/4.4m
15
235/106.6
|
| Xtreme Stand Complete Part No. 3009 |
|
|
Metals come in a wide variety of alloys and tempers that can greatly affect bending capacities.
Please contact us for recommendations on specific metals.
|
- Commercial Roofing and Siding
- Heating/Air Conditioning (HVAC)
- Patio Enclosures
- Emergency Repair Crews
- Sheet Metal Workers
- Commercial Kitchens/Ducts
- Solar Energy Panel Installers
- Automotive Sheet Metal Shops
- Property Management Crews
- Glazers and Sign Makers
POWERslot™ technology gives you more bending power with less energy resulting in a truly unique bending experience.
Added walls and hollows make TrimMaster® brakes the toughest machines out there while providing the same long service
life you’ve come to expect from a Van Mark Product.
 
- Heavy-duty extruded aluminum shop stand included with every Mark IV. The Xtreme™ Shop Stand will not rock,
rattle, roll or rust. Unit is fully detachable and collapsible for easy fast setup and transport.
- Hollow-core fixed hinge, bending hinge and base rail design makes this one tough brake. New FTA system (Fine-Tune
Adjustment), means you still have control over adjusting your machine, though you may never need to.
- Mark IV Industrial TrimMaster has the strongest bending capacities you can get in a portable brake.
- Unique Cam-Locking system locks to the thickness of the material
- Full loop locking and bending handles are ergonomic and provide for single operator use.
- Heavy-duty hinge provides years of dependable service without material curling at the ends or sags in the center.
- Mark IV Industrial now works with TrimCutter™ for quick clean material cutting right on the brake.
TrimCutter™ does not ride off the brake during cut.
Bend With Confidence
New POWERslot™ technology not only
provides increased bending llev-erage,
clad finishes are also protect-ed from
marring and scratching during bend.
 
|
