COMPACT II STARTER SYSTEM
Engel’s Coiline II blanking, notching and beading system can be either a stand alone system or the start of a complete automatic
fabricating system with TDF®. Our straightener, with four large diameter rolls, will remove coil set from either under or overfed
coils. The system is fully hydraulic including a heavy duty dual cylinder shear with bronze gibs. The low profile hydraulic notchers
will notch for S & Drive, TDF®, Pittsburgh or Snap Lock. (You can add the "flip of the switch" option to switch from TDF® to S &
Drive, or Pittsburgh.) Ring type beading is in accordance with SMACNA standards. The self-contained hydraulic power unit, with
its reservoir tank, is mounted safely within the solid side plates.
A PC based controller, with proprietary software, controls machine functions and can accept down loading from an IBM compatible
in-house computer. The control is expandable to handle a complete automatic duct fabricating system. The Compact Coiline II
includes 4 drop-in cradles with a maximum capacity of 15,000 lbs. per station. The coils are driven by Engel’s M-CDA-15-UF coil
drive assembly with a direct coupled drive. You can order any of Engel’s optional cradle systems. This system will process 5’
(1524 MM) galvanized steel into blanks for your plasma machine or notched blanks for "L" Section or full wrap ductwork. Cut-to-length
accuracy is +/- .020" (+/- 0.5MM).
FEATURES:
| Capacities: |
30 to 14 gauge, and up to 72" depending on model. |
| Straightening Unit: |
Heavy duty straightening rolls are 4-1/4 inch diameter |
| In Line Slitting: |
Available upon request. |
| Low Profile Notching: |
Dies are adjustable from S & Drive to TDF® with the flip of a switch.
Notcher dies are mounted in precision Die sets. |
|
