EAGLE MORLIN PITTSBURG AIR SEAMERS
The Morlin 5400 Hammer speeds up and takes the work out of the only tedious, costly, and time consuming job of
fabricating duct work - closing the "seam". This tool breezes along at speeds of 15 feet per minute on commonly
used gauges. This tool can actually save half of a man's time in making ducts, and do a better job! Just a couple
of taps at the center and ends of a standard length duct to secure the lock, then the Morlin 5400 does all the work.
It handles 22 - 30 gauge mild steel with no adjustment required. For straight runs, inside or outside radius, use it
in the shop or on the job.
The weight rests on the work and the position of the handle affords positive control and balance. It has a heavy
duty 115 volt AC-DC motor which should provide more than enough power for any job.
|
