LOCKFORMER BUTTON-PUNCH SNAPLOCK MACHINES
Form Ducts In A Snap!
The Button Punch Snap Lock machines form a two piece seam that greatly simplifies ductwork assembly. The male
seam is a button, the female seam is a lock and the two snap together for a flush corner. These machines can
form 20 to 30 gauge sheet metal into female locks on the inboard and button punched right angle flanges on the
outboard rolls at speeds of 60 - 65 fpm and are available in seven and nine forming stations machines. Not only
do these locks assemble twice as fast as traditional methods, but because the two pieces nest, they are easier
to transport too.
Standard with Lockformer quality construction, these machines have Baldor motors; high precision needle-type
bearings; heavy 3/4" chassis plate; case-hardened and ground roll shafts; and arc-welded steel stands protected
with Lockformer's top-quality primer and paint finish. Alemite fittings are easily accessible from a main
transmission bearing lubrication panel.
| |
Model 20 |
Model 24 |
| Forming Stations |
9 |
7 |
| Capacity |
20 - 26 gauge |
24 - 30 gauge |
| Forming Speed |
60 - 65 fpm |
60 - 65 fpm |
| Motor |
3 HP, 3600 RPM
230/460 volt, 3 phase |
2 HP, 3600 RPM
230/460 volt, 3 phase |
| Horizontal Roll |
4" |
4" |
| Vertical Roll Centers |
2.5" |
2.5" |
| Shaft Diameter |
1" |
1" |
| Dimensions (L x W x H) |
58.5" x 24" x 41" |
58.5" x 24" x 41" |
| Shipping Weight |
725 lbs. |
550 lbs. |
Auxiliary rolls are available for the outboard shaft.
|
