Specific Info On This Equipment

Reference Number: 2211

Condition: New

"If you need a machine and don't buy it, then you will ultimately find you have paid for it but don't have it."   Henry Ford

Full Product Description

Model:  KTM-3VKF
Table Size:  10" X 50"
Table Travel (X-Axis):  36"
Saddle Travel (Y-Axis):  15.75"
Knee Travel (Z-Axis):  16"
Quill Travel:  5"
Ram Travel:  20"
Spindle Motor:  3 HP (1750 RPM @ 60 HZ)
Power Requirements:  220/440 VOLTS, 3 PH, 60 HZ, 10/5 AMP
Spindle Speed:  Variable 60-500-4200 (2 RANGE, HI/LOW)
Spindle Taper:  R8 (NMTB-30 AVAILABLE)
Quill Diameter:  3.375"
Quill Feed Rate:  0.0015/0.003/0.006" PER REV
Drilling Capacity (Manual):  0.75" Diameter
Drilling Capacity (Power):  0.37" Diameter
Boring Capacity:  6.0" Diameter
Milling Capacity:  2.0 IN3/MIN
Max. Work Load (Center):  850 lbs.
Machine Weight (Approx):  3250 lbs.
Skid Dimensions:  72" X 72" X 84"H (Skid)

* 3HP spindle motor wiht electronic variable speed (EVS) AC-
frequency drive milling head.  NOTE: The AC-Frequency drive
can accept single phase power at 50% reduction in output of
HP....this is ideal where only single-phase power is
* Table, Saddle, and Knee Hardened & Ground
Dovetail Ways
* Precision ground leadscrews with backlash compensating
double nut
* Precision bored and ground miling head, with super
precision ABEC-7 bearings
* Meehanite castings, with built-in coolant reservoir in
machine base
* Centralized one-shot lubrication, with metered check-

ACU-RITE DRO System (2-axis, 0.0002"
Table Power Feed (X-AXIS)
Saddle Power Feed (Y-AXIS)
Knee Power Feed (Z-AXIS)    
Air Power Drawbar (maxi-torque)
Flood Coolant System 
Prolong Ultra-Cut Coolant (2.5 Gallons)
Riser Block (4")
Riser Block (6")
Riser Block (8")
Angle-Lock Vise (6")
Angle-Lock Vise (8")
Rotary Table (12", Vertical & Horizontal)
Clamping Kit
R8 Collet Set (11 PC., 1/8" TO 3/4")
DRO Installatoin charge