14 Ga. x 10', CHICAGO HYDRAULIC BOX & PAN, MODEL#HBPU.1014-6 **NEW**

Full Product Description

Model:  HBPU 1014-6
Bending length:  120 inches 
Capacity (mild steel):  14 Gauge(.075)**
Capacity (stainless steel):  18 Gauge(.048)**
Finger extension depth:  6 inches
Number and width of fingers with nose bar:  6 - 3 inches
10 - 4 inches
10 - 5 inches
 2 - 6 inches


** The bending capacity of the brake is achieved when using
the angle bar in the high position and forming a 1 inch
minimum flange on capacity material.
Use of the  inch insert bar with the angle bar in the low
position reduces the capacity of the brake four gauges.  Use
of the optional  inch insert bar with the angle bar in the
low position reduces the capacity of the brake seven gauges.

Machine weight:  5,500 lbs.


STANDARD EQUIPMENT:
* Removable Nose Bars
* Angle Bar
* Bolted Bottom Bar
* 1/2 inch Insert Bar
* Compact Hydraulic Power Unit
* Oil Level Sight gauge 
* Control Panel Features:
* On/Off Key Selector Switch
* Motor Start push button Bending Leaf Up/Down Pushbuttons
* Emergency stop p/b Clamp/Unclamp Pushbuttons
* Automatic Cycle P/B

ELECTRIC FOOT SWITCH - Clamps & Unclamps Top Leaf. Allows
operator mobility when loading and unloading material.

BEND ANGLE DIAL ADJUSTMENT - Adjustable cam and scale that
reads in degrees, actuates an electric limit switch for bend
angle control and repeatability of bends.

MATERIAL THICKNESS DIAL ADJUSTMENT - Reference scale for
speedier set up when adjusting clamping pressure.

BACK GAUGE - 25 " travel, rack & pinion type gauge with
hand wheel adjustment on right side of machine. Inch/Cm.
Scale.

INCH CONTROL - Bending leaf up/down pushbuttons allow
complete operator control of the bending leaf motion.

AUTOMATIC CYCLE - Actuating the "Automatic Pushbutton"
clamps the top leaf, raises the bending leaf to the preset
bend angle dial adjustment setting, lowers the bending leaf,
unclamps the top leaf.


ELECTRICAL EQUIPMENT
One 3 H.P. general purpose motor with direct mount hydraulic
pump for operation on 220 or 440 volts (choose one), 3 PH,
60HZ with 110 volt control circuit.

Shipped without Mobil DTE26 hydraulic oil.

Optional Electric powered Back Gauge with Digital Readout
Optional 1/4 inch Insert Bar:    (Used for offset bends less
than 1/2" apart)
Optional set of radius formers:  (Great for making gutters
and mouldings)
Optional Radius (" max) Nose Bars: 3" , 4" , 5" , 6" .
Optional Set of Extension Fingers
Optional Set Open End Fingers